It forced the battery to provide a 'well-known' voltage to thé charger. ![]() I required the two wires from the 2.5V battery pack and held them against the two cables arriving out of drone 7.4V battery, held it presently there for about 30 seconds or so, viewed the volt meter gradually rise and after that just connected it into the electric battery charger/balancer. You can inform which will be which if you consider the battery out of its situation and appear in the inside of at the connection. Controller operation just the same as other drones, providing yaw, steering, altitude hold and so on. No matter mountaineering, outings, or family parties, it can help you capture every eternal moment. Where the charger attaches in with a three wire connection, I put two cables sticking out of the positive and the neutral. NAVIGATOR equipped with HD camera and built in altitude hold function to meet your selfie demand. I then hooked a volt méter to two cables and stuck the finishes of those intó the prongs óf the electric battery which connect best into the drone (it read like 7mSixth is v). ![]() What I do was consider a AA 1.5V battery pack that acquired a two wire connector connected to it and trapped the two cables in each ditch on the finish. This APP function: 1.Remote control the four axis aircraft by mobile. It'beds caused by one of the tissues of the electric battery being used up, the charger/balancer doesn't 'understand' it. ![]() I got the exact same thing occur to mine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |